Journal Press India®

Solar PV Panel Area Requirement and Performance - Specific Panel Sizing at Different Locations

https://doi.org/10.51976/jfsa.512208

Author Details ( * ) denotes Corresponding author

1. * Utkarsh Singh, Design Engineer, Maxbros Venture India Pvt Ltd., India (utkarsh.vns1122@gmail.com)
2. Jyoti Vimal, Department of Mechanical Engineering, Madhav Institute of Technology Science, Gwalior, Madhya Pradesh, India (jyotivimal1805@gmail.com)
3. Tushar Singh, Production Engineer (PPC), Indo autotech Ltd., (tushar11singh99@gmail.com)
4. Manoj Kumar Shukla, Selection Grade Lecturer (TPO), Department of Mechanical Engineering, Kalaniketan Polytechnic College, Jabalpur, India (mksmact@gmail.com)

One of the most popular renewable power generation technologies in use today is solar photovoltaic (PV) technology. In this essay, the efficiency of PV panels at three separate Indian locations—Mathura, Ladakh, and Bikaner—is compared for some of the same environmental variables at the same time and place. To get the necessary voltage at the load side, a boost converter is integrated with the PV panel. To test and track changes in parameters of the panel and at the load, the simulation model is simulated using simulation software for various solar irradiation and temperature. The existing panel’s efficiency will change after these numbers are obtained. The impact of high cell temperature and solar irradiation is shown based on the previously determined values of performance parameters for the panel. The values of the performance parameters will also be used to determine the size of the PV Panel and the area needed for it to generate 1 Kilo watt. Observations for various environmental circumstances will be recorded.

Keywords

Performance; Cooling; Technique; Observations; Electricity

  1. C. Marimuthu, “A Study of Factors Affecting Solar PV Cell through Matlab / Simulink Model This study considers the Grid Interactive Roof Top Solar,” IJRSI, vol. I, no. Iii, pp. 21–25, 2014.
  2. P. Löper et al., “Analysis of the temperature dependence of the open-circuit voltage,” Energy Procedia, vol. 27, pp. 135–142, 2012, doi: 10.1016/j.egypro.2012.07.041.
  3. K. Umadevi and C. Nagarajan, “Photovoltaic System With Dc-Dc Boost Converter Topology Using Psim Software,” Int. J. Curr. Res. Mod. Educ., no. NCFTCCPS-2016, pp. 51–60, 2016.
  4. S. Chakraborty, W. Hasan, and S. M. B. Billah, “Design and analysis of a transformer-less single-phase grid-tie photovoltaic inverter using boost converter with Immittance conversion topology,” 1st Int. Conf. Electr. Eng. Inf. Commun. Technol. ICEEICT 2014, 2014, doi: 10.1109/ICEEICT.2014.6919107.
  5. P. Dwivedi, K. Sudhakar, A. Soni, E. Solomin, and I. Kirpichnikova, “Advanced cooling techniques of P.V. modules: A state of art,” Case Stud. Therm. Eng., vol. 21, no. December 2019, p. 100674, 2020, doi: 10.1016/j.csite.2020.100674.
  6. J. Ahmed and Z. Salam, “A Modified P and O Maximum Power Point Tracking Method with Reduced Steady-State Oscillation and Improved Tracking Efficiency,” IEEE Trans. Sustain. Energy, vol. 7, no. 4, pp. 1506–1515, 2016, doi: 10.1109/TSTE.2016.2568043.
  7. P. Kumar and R. Dubey, “Efficiency Improvement of Photovoltaic Panels by Design Improvement of Cooling System using Back Water Cooling Tubes,” Int. J. Eng. Res. Technol., vol. 7, no. 01, pp. 74–77, 2018, [Online]. Available: www.ijert.org.
  8. K. K. Dixit, I. Yadav, G. K. Gupta, and S. Kumar Maurya, “A Review on Cooling Techniques Used For Photovoltaic Panels,” Int. Conf. POWER Electron. IOT Appl. Renew. ENERGY ITS Control., pp. 360–364, 2020, doi: 10.1109/parc49193.2020.236626.
  9. I. Yadav, S. K. Maurya, and G. K. Gupta, “A literature review on industrially accepted MPPT techniques for solar PV system,” Int. J. Electr. Comput. Eng., vol. 10, no. 2, pp. 2117–2127, 2020, doi: 10.11591/ijece.v10i2.pp2117-2127.
  10. S. K. Kollimalla and M. K. Mishra, “A novel adaptive p&o mppt algorithm considering sudden changes in the irradiance,” IEEE Trans. Energy Convers., vol. 29, no. 3, pp. 602–610, 2014, doi: 10.1109/TEC.2014.2320930.
  11. N. Khordehgah, A. Żabnieńska-Góra, and H. Jouhara, “Energy performance analysis of a PV/T system coupled with domestic hot water system,” ChemEngineering, vol. 4, no. 2, pp. 1–14, 2020, doi: 10.3390/chemengineering4020022.
  12. E. Gordo, N. Khalaf, T. Strangeowl, R. Dolino, and N. Bennett, “Factors Affecting Solar Power Production Efficiency,” New Mex. Supercomput. Chall., pp. 1–18, 2015.
  13. Z. Arifin, D. D. D. P. Tjahjana, S. Hadi, R. A. Rachmanto, G. Setyohandoko, and B. Sutanto, “Numerical and experimental investigation of air cooling for photovoltaic panels using aluminum heat sinks,” Int. J. Photoenergy, vol. 2020, 2020, doi: 10.1155/2020/1574274.
  14. S. A. M. Maleki, H. Hizam, and C. Gomes, “Estimation of hourly, daily and monthly global solar radiation on inclined surfaces: Models re-visited,” Energies, vol. 10, no. 1, 2017, doi: 10.3390/en10010134.
  15. R. Mazón-Hernández, J. R. García-Cascales, F. Vera-García, A. S. Káiser, and B. Zamora, “Improving the electrical parameters of a photovoltaic panel by means of an induced or forced air stream,” Int. J. Photoenergy, vol. 2013, 2013, doi: 10.1155/2013/830968.
  16. R. Anusuyadevi, P. Suresh Pandiarajan, and J. Muruga Bharathi, “Sliding mode controller based maximum power point tracking of DC to DC boost converter,” Int. J. Power Electron. Drive Syst., vol. 3, no. 3, pp. 321–327, 2013, doi: 10.6084/m9.figshare.1143828.
  17. W. Lubon et al., “Assessing the impact of water cooling on PV modules efficiency,” Energies, vol. 13, no. 10, 2020, doi: 10.3390/en13102414.
  18. D. Dhupal, S. R. Dixit, S. Pattanayak, R. R. Routray, and A. K. Behura, Methodologies to Optimize Engine. Springer Singapore, 2019.
  19. J. Siecker, K. Kusakana, and B. P. Numbi, “A review of solar photovoltaic systems cooling technologies,” Renew. Sustain. Energy Rev., vol. 79, no. May 2018, pp. 192–203, 2017, doi: 10.1016/j.rser.2017.05.053.

 

Abstract Views: 1
PDF Views: 165

Advanced Search

News/Events

Institute of Managem...

Deccan Education Society Institute of Management Development and Re...

S.B. Patil Institute...

Pimpri Chinchwad Education Trust's S.B. Patil Institute of Mana...

D. Y. Patil IMCAM, A...

D. Y. Patil Institute of Master of Computer Applications & Managem...

Vignana Jyothi Insti...

Vignana Jyothi Institute of Management International Conference on ...

Department of Commer...

Department of Commerce, Faculty of Commerce & Business, University...

Birla Institute of M...

Birla Institute of Management Technology (BIMTECH) 3rd Pritam Singh M...

OP Jindal University...

OP Jindal University, India 4th International Conference on  ...

Department of MBA, N...

Department of MBA, Narayana Engineering College Nellore International...

Vignana Jyothi Insti...

Vignana Jyothi Institute of Management Conference Proceedings,...

Online Proceedings R...

Conference Proceedings, March 2023 ISBN: 978-81-956810-6-8 ...

By continuing to use this website, you consent to the use of cookies in accordance with our Cookie Policy.