Vol 5 , Issue 2 , April - June 2017 | Pages: 193-206 | Research Paper
Received: January 25, 2017 | Revised: February 20, 2017 | Accepted: February 28, 2017 | Published Online: June 15, 2017
Author Details
( * ) denotes Corresponding author
Every manufacturing industry aims at producing a large number of products within lesser time.This experiment shows the optimization of cutting parameters for surface roughness & material removal rate in the turning process to obtain the optimal setting for the process parameters and analysis of variance is used to analysis the influence of cutting parameters while turning. Orthogonal array is also beenused and prepared to obtain the optimal levels and to analyse the effect of each turning parameters. The S/N ratio is been calculated to structure the ANOVA table and study the performance characteristics in turning process. ANOVA analysis gives the contribution percentage of every process parameter. The number of experiments are to be obtained using full factorial design for optimal result.
Keywords
Taguchi method; Cutting parameters; Turning, ANOVA; Surface roughness.