Design of a Wind Turbine for Self-Renewable Electric Vehicle

B Chiranjeevi Teja; V. Bindu Niharika

doi:https://doi.org/10.51976/ijari.832010

Submit Manuscript Login / Register Subscribe

Home Page

Editorial Advisory Board

Mission, Aims & Scope

Current Issue

Design of a Wind Turbine for Self-Renewable Electric Vehicle

B Chiranjeevi Teja, V. Bindu Niharika

Vol 8 , Issue 3 , July - September 2020 | Pages: 63-66 | Research Paper

https://doi.org/10.51976/ijari.832010

Received: January 17, 2020 | Revised: May 29, 2020 | Accepted: July 30, 2020 | Published Online: September 15, 2020

Author Details ( * ) denotes Corresponding author

1. * B Chiranjeevi Teja, Department of Mechanical Engineering, Anil Neerukonda Institute of Technology & Sciences, Visakhapatnam, Andhra Pradesh, India (chiranjeeviteja7@gmail.com)

2. V. Bindu Niharika, Department of Mechanical Engineering, Anil Neerukonda Institute of Technology & Sciences, Visakhapatnam, Andhra Pradesh, India

The project aims to design a wind turbine from which the wind energy is caused by the relative motion between vehicle and the wind. By using the auxiliary power sources electric vehicle itself generates the electric power required to drive the vehicle during dynamic condition. Compared to conventional fuels used in modern vehicles the energy storage capacity of this is very low, due to the lack of capability of storing sufficient amount of energy to run the vehicle for a long time. The efficiency and performance of electric vehicles are better than the engine driven vehicles. Utilizing the wind energy caused by the relative motion between the vehicle and the wind by auxiliary power source like horizontal, vertical wind turbines can generate the electric power required to drive the vehicle during running condition.

Keywords

Electric vehicles; Wind energy; Wind turbine; Renewable energy.

Ferdous et. al. Electric Vehicle with Charging Facility in Motion using Wind Energy, world renewable energy congress 8-13 may 2011, Linköping, Sweden.

SK Jeyakanthan, V Sudharshan. Design and Fabrication of Self-Charging Electric Vehicle” in International Journal of Innovative Research in Science, Engineering and Technology, 6(9), 2017.

Murat Gökçek, Mustafa Serdar Genç„ ‟Evaluation of electricity generation and energy cost of wind energy conversion systems (WECSs) in Central Turkey‟‟ Applied Energy, Volume 86, Issue 12, December 2009, Pages 2731-2739

A Ucar, F Balo. Investigation of wind characteristics and assessment of windgeneration potentiality in Uludag-Bursa, Turkey Appl Energy, 86 (3), 2009, 333–339

G Sahu, RK Rathore. Determination of Torque Produced by Horizontal Axis Wind Turbine Blade Using FSI Analysis for Low Wind Speed Regime, International Journal of Innovative Science, Engineering & Technology, 2(5), 2015.

A Sarkar, DK Behera 2012. Wind Turbine Blade Efficiency and Power Calculation with Electrical Analogy, International Journal of Scientific and Research Publications, 2(2).

AB Deepika, S Nandhini, R Rajalakshmi, D Shobana 2017. Power Production in Electrical Vehicle Using Self Generation and Regeneration, International Research Journal of Engineering and Technology (IRJET), 4(3).