Vol 8 , Issue 4 , October - December 2020 | Pages: 115-119 | Research Paper
Received: July 29, 2020 | Revised: October 20, 2020 | Accepted: October 28, 2020 | Published Online: December 15, 2020
Author Details
( * ) denotes Corresponding author
Wearable cloths undergo a lot of shear stretching. It is important to study the role of printing parameters which may improve adhesion capacity between printed thermoplastic material and the cotton fabric. In this paper, effort has been made to determine the best set of printing parameters for effective FDM based printing on cotton fabrics using 3D printer. Printed samples are tested in shear mode of loading to evaluate adhesion capacity of thermoplastic printing material on cotton fabrics. Cotton fabric with rectilinear infill pattern has been selected for investigating in shear mode condition. Using an infill percentage of 80 per cent gives best adhesion strength. This study may further be used for printing smart material on fabric substrate.
Keywords
Fused Deposition Modeling, adhesion capacity, fill angle, z-offset distance.